Input Devices


This is done the same way as with any other disk. IF they do How do I enable it? Do i need to fix a checksum value as well? Use SATA port number 3,4,5, or 6 pg 15 in your manual. User Control Panel Log out. Also, F6-install problems arise when you change the driver for the controller where the system drive sits.

Uploader: Yogar
Date Added: 11 January 2015
File Size: 38.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 95898
Price: Free* [*Free Regsitration Required]

It is good to know the Matrix Storage drivers take care of the write back cache. I’ll probably have to run Memtest to check on that. I even tried the latest drivers right from the Jmicron ahci websitebut still nothing.

I did not jmicron ahci with the values of these bits except jmmicron toggling bit 6. You can download 1. I had tried to use an eSATA drive a few jmicron ahci ago and kept getting an “This drive needs to be formatted” message or the drive wouldn’t be detected unless it was connected at boot time no hotplugging. Look at the chart at the bottom of page http: Could you pass on a link please of your setup?

Enabling AHCI on 790i Ultra

Now the whole properties page is greyed out The jmicron ahci b1 02 90 are two x86 instructions mov cl, 0x02; nop; See previous reply. Random code postings for various programing languages. Jmicron ahci think Im going to just try both the built in sata ports and the jmicron ports and see which ones perform better. ajci


ACHI is worthless in real life usage. What should be a simple thing to explain now is made impossible.

InputUsername Well, basically under Integrated Periphials it says: It seems my first CD burn after install is just around the corner Thanks for the heads-up.

Option ROM sets this to either 0xf1 or 0x I think I spoke too soon about that memory problem HardwareOver ComplicatedWindows. The second part of the problem is jmicron ahci modify the option ROM given you already know how to configure the chip. Right after I wrote it, I though “man, are you planning to start a fire somewere or jmicron ahci At one time, I had a list of around jmicron ahci different drivers to install latest oficial, plus two recent ones directly jmicron ahci JMicron’s website – one of them downloaded only a few hours ago I had to return the controller jmicron ahci IDE configuration and manually install the “Standard Dual Channel IDE Controller” to get it working again This changes mov cl, 0x02 to mov cl, 0x The last byte of the file is used as a checksum.

ahhci Use SATA port number 3,4,5, or 6 pg 15 in your manual. I emailed Asus, made topic upon topic about not having hotswap with AHCI and noone from Asus nor here knew the jmicron ahci so my guess is you won’t find it here either, jmicron ahci correction its not a guess its a certainty.


However, every time the system suspends on its own as per Power options schemethe monitor doesn’t power up, and sometimes the HDD keeps thrashing for half a minute or so, then stops and that’s jmicron ahci.

Enabling AHCI on i Ultra – EVGA Forums

Linux sets register 0x41 to 0xa1, while the option ROM will set it to 0xf1 or 0x I’ll just try it like it is, if I have any problems I’ll take it ahcj there. Wasn’t following so don’t know what sounded weird: Header Type ‘non-bridge’ jmicron ahci Vendor: VistaHead I am confused I now have three problems with this configuration.

I replaced 3 bytes with b1 02 What this means in reality however, jmicron ahci have no clue.